Mon-Fri: 7AM-7PM, Sat: 8AM-5PM Licensed & Insured [email protected] Serving Gary, IN

Driveway Cleaning for Brick in Gary, IN

Low-pressure wash for brick. Driveway pressure washing that removes dirt, mildew, tire marks and many oil and rust stains for an even, clean finish. Typical cost $150-$400.

When we handle driveway cleaning for brick in Gary, IN, it comes down to three things: protecting your plants and property, cleaning with the right method, and walking the job with you at the end. For brick, that means low-pressure wash.

How we clean it

Low-pressure washCleaning method
Usually 500-1,500 PSI with a wide fan tip, held well back from the mortarPressure

Cleaning solution: Soft wash for algae and mildew; a masonry-specific cleaner for efflorescence and mortar haze.

Caring for brick

Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit. Organic growth comes off with a soft wash; mineral deposits such as efflorescence need a masonry-safe cleaner instead of more pressure.

Avoid: Zero-degree tips and close-range blasting that erode mortar joints, and strong acids on brick that hasn't been pre-wet.

How often: Every 2-3 years for most homes.

When to book driveway cleaning for brick

  • Dark, blotchy or striped concrete
  • Black mildew along edges and in shaded areas
  • Oil spots and tire marks
  • Rust stains from sprinklers or fertilizer
  • Weeds and moss in cracks and joints

Where the grime comes from

  • Vehicle drips and tire rubber
  • Dirt, pollen and leaves ground in by traffic
  • Mildew in shaded and damp spots
  • Iron in well water or fertilizer leaving rust marks

What you can do yourself

  • Blot fresh oil with cat litter and sweep it up after a day
  • Sweep regularly so leaves don't leave tannin stains
  • Fix leaking vehicles to stop new spots
  • Avoid deicers that contain ammonium nitrate or ammonium sulfate, which damage concrete

Not sure what you're looking at? The free stain identifier and safe pressure guide explain each stain and surface.

What can go wrong with DIY pressure washing

  • Stripes and swirl marks from using a wand instead of a surface cleaner
  • Etched concrete from a narrow tip held too close
  • Oily wash water running into the street and storm drains
  • Spreading oil around instead of lifting it

What happens on the day

  1. Sweep and inspect the driveway and note stains
  2. Degrease oil spots and pre-treat mildew
  3. Clean the whole surface with a rotary surface cleaner
  4. Detail edges, joints and expansion cracks
  5. Rinse, post-treat and walk the driveway with you

Driveway Cleaning for Brick cost in Gary, IN

$150-$400Typical range for a typical two-car driveway
1-2 hoursTypical time on site
Once a yearRecommended frequency

What moves the price:

  • Size: square footage of siding, roof or flatwork
  • Condition: heavy growth, old stains and peeling finishes take longer
  • Access: number of stories, roof pitch, slopes and how close we can park
  • Add-ons: sealing, gutter brightening and other services done in the same trip

These are typical U.S. ranges, not a quote. You get an exact price before any work starts. For a quick estimate, try the pressure washing cost calculator.

Other services for brick

Driveway Cleaning for Brick in Gary, IN

In Indiana, concrete has to deal with summer mildew and winter salt and freeze-thaw cycles. Annual cleaning and a sealer every few years help it last.

Besides Gary (ZIP codes 46401, 46402, 46403, 46404, 46406 and more), we handle driveway cleaning for brick in Lake Station (5.7 mi), Griffith (6 mi), Highland (6.1 mi) and Hobart (6.3 mi). Call (555) 010-0000 for a free quote in Gary.

Driveway Cleaning for Brick: frequently asked questions

How much does driveway cleaning for brick cost in Gary, IN?

Driveway Cleaning for Brick typically costs $150-$400 for a typical two-car driveway, and usually takes 1-2 hours. The exact price depends on the size and condition, and you get it before any work starts. Call (555) 010-0000 for a free quote.

Do you use high pressure for driveway cleaning for brick?

For brick: usually 500-1,500 PSI with a wide fan tip, held well back from the mortar. What we avoid: zero-degree tips and close-range blasting that erode mortar joints, and strong acids on brick that hasn't been pre-wet. The cleaning solution does most of the work, followed by a gentle rinse.

Is driveway cleaning for brick safe for my plants and pets?

We pre-wet plants and lawns, keep cleaning solutions diluted to what the surface needs, and rinse landscaping again when we finish. Keep pets and children inside until surfaces are rinsed and dry.

How often should I schedule driveway cleaning for brick?

Every 2-3 years for most homes. Shade, nearby trees, humidity and heavy traffic mean more frequent cleaning; sunny, dry spots can go longer. Our free cleaning frequency tool gives a recommendation for your climate.

What if it rains on the day?

Light rain doesn't stop most washing, but heavy rain, high wind, lightning and freezing temperatures do. If the weather isn't right, we reschedule at no charge. Our work is backed by a satisfaction guarantee.

More services

Popular Exterior Cleaning Services in Gary, IN

Rust Stain Removal for Concrete

Pressure wash with a surface cleaner. Plain broom-finish concrete is the surface pressure washing is made for.

Typical $150-$500

HOA & Apartment Pressure Washing

Building washing, sidewalks, breezeways, pools and amenity areas for HOAs, apartments and condos.

Typical $800-$5,000

Gum Removal

Removing chewing gum from sidewalks, entrances and plazas with hot water and steam.

Typical $200-$1,000

Exterior Mold & Mildew Removal for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $250-$700

Roof Cleaning for Metal Roofs

Soft wash. Painted metal roofs collect dirt, mildew and oxidation chalk.

Typical $400-$1,000

Pressure Washing for Asphalt

Low-to-moderate pressure wash. Asphalt is softer than concrete and is held together by its binder, so it is washed at lower pressure.

Typical $150-$600

Patio Cleaning for Concrete

Pressure wash with a surface cleaner. Plain broom-finish concrete is the surface pressure washing is made for.

Typical $150-$400

House Washing for Aluminum Siding

Soft wash. Older aluminum siding often has a chalky, oxidized finish.

Typical $300-$700

Parking Lot & Garage Cleaning for Concrete

Pressure wash with a surface cleaner. Plain broom-finish concrete is the surface pressure washing is made for.

Typical $500-$3,000

Gum Removal for Pavers

Pressure wash with a surface cleaner. Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them.

Typical $200-$1,000

Paver Cleaning & Sealing for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $600-$1,800

Patio Cleaning

Patio cleaning for concrete, pavers and natural stone, with the pressure and cleaner matched to the material.

Typical $150-$400

Ready for a cleaner home or business?

Get a free pressure washing quote in Gary, IN. Tell us what needs cleaning and we'll give you a price and the next available date.

Call NowFree Quote